Keg Post O-Rings - 10 Pack of Colour Coded Silicone

Colour coded Yellow and Red Ball Lock Keg Post O-Rings. Silicone for superb malleability and spring back memory performance.

We've all been there, not looking or not thinking and trying to put a gas disconnect on a liquid post. Yes, there's a notch in it. Yes, there are words IN and OUT. But you're busy! You don't have time to go searching, it should just be in your face obvious that it's a liquid or a gas post. KegLand finally has the answer with the long awaited colour coded Gas and Liquid Post Sets Red & Yellow.

FAQ
Why not Low2 O-Rings? Aren't they supposed to be better?

There is one fundamental reason why we didn't and shouldn't use Low2 O-rings for a post. Spring-Back Memory - Leak prevention.

Low2 has a lot of memory, while silicone does not. This means that if you use a Low2 O-ring on your keg posts, keep the keg cold in the fridge, and have everything connected, then later remove and reattach the disconnects, the O-ring's memory could be slightly off unless you reseat it in exactly the same position. That misalignment can lead to a potential leak.

We use Low2 on the Hatch Lid O-Ring because its a face seal that can withstand 100's of PSI worth of pressure, and even if flattened slightly under pressure it can be reseated quite easily.

A Radial Seal (Post O-Ring) is much harder to manipulate. 

All independent testing with Low2 Keg Lid O-rings was done with silicone post o-rings. So rest assured you're getting the best possible product that means less leak spots, and better chemical resistance and performance.

Comes with:
5 x Yellow Liquid In Post O-Rings
5 x Red Gas Out Post O-Rings

We would recommend applying food grade lubricant to your o-rings on a regular basis to prolong their life. Especially after deep cleaning.

From: Kegland