Sort by:
Mangrove Jack's No Rinse Sanitiser effectively sanitises brewing, wine making, and distilling equipment.
Unlike conventional alkaline powdered sanitisers, Mangrove Jack's No Rinse Sanitiser requires no rinsing. It makes the vital job of sanitising equipment easy and effective. It utilises active oxygen, which breaks down to leave only oxygen, water, and minerals found naturally in water.
Contains: Sodium Percarbonate 880g/kg
Star San is a no rinse sanitiser made from a blend of phosphoric acid and dodecylbenzenesulfonic acid. This synergistic blend provides a unique killing system that is unaffected by excessive organic soils.
Star San is also a self-foaming sanitiser. It can be applied through a foamer to produce self-adhering sanitising foam for external sanitation. Star San is also an excellent sanitiser for hand application. Sanitising with Star San on a daily basis will leave equipment in an acid condition that will eliminate water spotting. It is not recommended to use Star San on soft metals because of the acid nature of this product.
BENEFITS
- Broad Spectrum Bactericide and Fungicide
- Not Affected by Organic Materials
- No Rinse Requirement When Used at 300 ppm
- Accepted by U.S.D.A. as a General Sanitiser in all Departments
GENERAL USE DIRECTIONS
All surfaces should be cleaned and rinsed before sanitising with Star San.
Directions: At a dilution rate of 1 ounce (29.57ml) to 5 gallons (18.93L) of water, Star San will provide 300 ppm of dodecylbenzenesulfonic acid. After 1 to 2 minutes contact time, drain sanitising solution from equipment thoroughly. Do not rinse. If using Star San in CIP, proper water balance must be maintained or your pump may cavitate. If used at a rate of more than 300 ppm, a potable rinse is required.
Saniclean is a low-foaming, acid based, final rinse sanitiser.
- Effectively removes odours and flavours especially from draft lines or other dispensing products.
- Great for both CIP and manual applications.
- Not to be used on soft metals such as aluminium.
Instructions:
- Thoroughly clean surfaces with PBW or compatible cleaner.
- Mix 2 oz. (60ml) Saniclean for every 5 gal. (19L) of water. (Will be low-foaming)
- Apply on surface with cloth, mop, sponge, spray, or immersion.
- If using spray application, use a coarse mist, pump, or trigger sprayer and spray 15-20cm from surface and follow up with a brush or sponge.
- Allow for contact time of at least 2-3 minutes.
- Drain, but do not rinse.
From: Five Star Chemicals
